After here and there looking for info steps to install heat sinks and fans in search engines with keywords How to install heatsinks and fans, tutorials on installing heat sinks and fans, Tips on installing heat sinks and fans, and finally a little relieved after you meet here… Hehe…
As most microprocessors produce a lot of heat which can cause problems in the system. One way to remove heat from the processor is to use a heat sink and cooling fan. Pr
ecise installation is crucial for unit performance. Although the heat sink can be installed before mounting the processor chip on the motherboard, there is still a possibility of damage to the chip pins. Fans installed before CPU installation can only be performed on a Pentium II processor. Below sample heat sink image
Steps to install heat sinks and Cipason Socket 7 and other processors and socket typ
es: Step 1
If the CPU fan has not been plugged in with a heat sink, then use the supplied screw with the fan to set it up on the heat sink.
Some setups use heat sink compounds or thermal pasta. Install the heat sink compound on the chip surface. Give one thin layer, enough to seal the chip surface. The heat sink or thermal fat compounds increase the contact between the CPU surface and the heat sink, which will then increase the heat dissipation.
Install the heat sink carefully. Place the heat sink directly on top of the processor and press slowly. The current Heat sink in the market uses a set of clips on both sides as a holder. It may take a bit of compulsion to put the clip in place. If th
e position is not precise, the clip will be difficult to put in the correct position. Sometimes it takes a few times to get the right position. In other cases, the heat sink compound is the only adhesive between the heat sink and the processor.
Check if the fixed heat sink has good contact with the processor chip surface. Usually when the heat sink is mounted upside down, the chip surface and the heat sink become stretched. When this happens, remove the heat sink, rotate it, and try to reattach it.
Step 5 Remo
ve excess heat sink or thermal paste compounds that may be overloaded to the side of the contact surface.
Carefully plug the power cord of the fan on the electric pin of the fan on the motherboard. Processors that are already in one package will usually be accompanied by a fan and a heat sink that has been installed.
The price may be more expensive but more comfortable and safe to install. A well-packaged processor is usually the original equipment manufacture (OEM) and has better coverage than a fanless processor and heat sink.
Quite up here hopefully info steps install a heat sink and a fan can help. Thank you for your visit and don't forget to share it with your friends in need of information about the heat sink and fan steps. Sou